Other Avayanic Web Sites!

Project Board Mother Board (PBMB)

Download Data sheet
Download Gerber Files for this board

The Project Boards can now be nested to add more power to your embedded system or robotic application. Using conventional edge card slot connectors, a bus has been devised that will allow up to three of our project boards to share resources such as power, serial communication or whatever other signal the user wishes to interconnect. The board is generic and the prototyping area allows the user to distribute the I/O as needed.

The three edge connectors share 62 lines with a fourth set of parallel lines than can be used to interface them with the prototyping area. A MAX232 driver already incorporates RS-232 to TTL level conversion for data coming from the serial port at the top right corner. 24V or 12V can be administered to the board which will generate 5V up to 1A to power up logic. A good prototyping area ensures easiness at project development time.

How To Buy:(Check Our Clearance Sale)

Single PCB:

For users only wishing to enable a few of the available functions, the PCB is the most affordable solution.

Kit:

The kit includes the PCB, (3) 62 pin 100 mil edge connectors, (3) Two Position Power Connector, (1) 9 pin female DB9 connector, (1) 7812T Voltage regulator, (1) 7805T Voltage regulator, (6) 1 uf electrolytic capacitor, (1) 22 uf electrolytic capacitor and (1) 47 uf electrolytic capacitor.

Fully Assembled:

A fully assembled and tested board can also be purchased if the user does not feel like soldering the components into the project board.

Do not forget to tune into www.superstepper.com for more information on the superstepper architecture.